The Strength and type of steel used in a bolt is supposed to be indicated by a raised mark on the head of the bolt. The type of mark depends on the standard to which the bolt was manufactured. Most often, bolts used in machinery are made to SAE standard J429, and bolts used in structures are made accoring to various ASTM standards. The tables below give the head markings and some of the most commonly-needed information concerning the bolts. For further information, see the appropriate standard.

SAE Bolt Designations
SAE Grade No.	Size Range	Tensile Strength (ksi)	Material	Head Marking
1	1/4 through 1 1/2	60	Low or medium carbon steel
2	1/4 through 3/4 7/8 through 1 1/2	74 60
5	1/4 through 1 1 1/8 through 1 1/2	120 105	Medium carbon steel, quenched and tempered
5.2	1/4 through 1	120	Low carbon martensite steel, quenched & tempered
7	1/4 through 1 1/2	133	Medium carbon alloy steel, quenched & tempered
8	1/4 through 1 1/2	150	Medium carbon alloy steel, quenched & tempered
8.2	1/4 through 1	150	Low carbon martensite steel, quenched & tempered

ASTM Bolt Designations
ASTM Standard	Size Range	Tensile Strength (ksi)	Material	Head Marking
A307	1/4 through 4	60	Low carbon steel
A325 Type 1	1/2 through 1 1 1/8 through 1 1/2	120 105	Medium carbon steel, quenched and tempered
A325 Type 2	1/2 through 1 1 1/8 through 1 1/2	120 105	Low carbon martensite steel, quenched & tempered
A325 Type 3	1/2 through 1 1 1/8 through 1 1/2	120 105	Weathering steel, quenched & tempered
A449	1/4 through 1 1 1/8 through 1 1/2 1 3/4 through 3	120 105 90	Medium carbon steel, quenched and tempered
A490 Type 1	1/4 through 1 1/2	150	Alloy steel, quenched and tempered
A490 Type 3	1/4 through 1 1/2	150	Weathering steel, quenched and tempered

Often one will find "extra" marks on a bolt head - marks in addition to those shown above. Usually, these marks indicate the bolt's manufacturer.

ASTM A325 Type 2 bolts have been discontinued, but are included above because they can be found in existing structures. Their properties can be important in failure investigations.

While the bolts shown are among the most common in the U.S., the list is far from exhaustive. In addition to the otehr bolts covered by the SAE and ASTM standards, there are a host of international standards, of which ISO is perhaps the most well-known.